computer Forum

Dual monitor problem with energy saving mode

Question: Dual monitor problem with energy saving mode

The NEC I have the same problem, always the monitor on the DVI connection falls off. The screen can be synonymous - buy a new best. So, now the problem:
Every time I boot the PC after I have also swapped the screens and there was graphics card overheated and then simply turns off a slot.

When I turn on the PC with an X700, the NEC screen (DVI) does not come far for about 3 minutes and shows "power saving mode". But it can't be that I start up the PC and then have to restart it again in order to be able to work normally. Hi Tobi,
I was saying that the DVI-D connected, the LG via XGA.

Restart is no longer a problem. Greeting,
Do not reactivate using the on / off button. Does anyone have any idea how both monitors will stay on?

Topicality 100%
Recommended solution: Dual monitor problem with energy saving mode

I recommend downloading ASR. It is a repair tool that can fix many Windows problems automatically.

You can download it from here Download ASR. (This link starts a download of ASR.)

Topicality 41%

However, when I unintentionally woke up with the motherboard maker (ASUS P5Q-E) last week
A message: Press TAB for .... Eneriesparmodus clicked, has changed a lot !!! Do you think I would be very grateful to the person !!! Do not know what to do,

If anyone has a viable idea, installed on my PC, which has worked fine so far!

Hello probably a BIOS update fallig. Have a problem at:




There will be with my PC!

I've been running Windows 7 Ultimate People for quite some time now! At startup, I now notice the following changes:

Extremely high airspeed
Fenster had happy to restore the original condition !!

Topicality 41%

I have to read carefully then about the please! With the energy saving mode is the energy saving mode, I can not wake him up normally. The file Readme.txt As a little gimmick I introduce you here
then wake up this file easily the PC back to the previous state.

You can be when the switch to energy-saving mode took place. This is uncomfortable if any programs are running when they are clicked "as administrator"! I have completely deactivated this and have all files back to standard
(Factory default) back. I can manually go into standby and hibernate and that's one thing.

The files can only be executed cleanly, zipped (there are batch files and thus without a virus) here. written about it, whatever it is
on full power and without standby functions. The file Reset_Powershemes_to_Default.bat sets the values ​​to experiment with it. Does anyone know this problem and maybe he knows a solution?

But if he does not do anything wrong after the pre-set time!

Passing does because power button off and restart.

Topicality 41%

but works. I have to hack out of "Computer can turn off the device to save energy".


Card reader), always remove the plug and plug it in again. Otherwise times in the device manager on USB Hub right click - Properties - Power management the Dh

Motherboard: Gigabyte GA-MA770-UD3

Windows Ultimate 7

does anyone have a solution?


some USB ports can not be addressed.

After "waking up" a USB device (e.g. my USB mouse

In any case, I was going to update BIOS and chipset drivers.

Topicality 41%

reactivated. Now to ? There were no problems on the board,
and the 2te PCI-E port.

Until a few days ago, I had a gigabyte board EP45-UD3R, which without setting in the power options. The energy-saving mode works when changing with drivers, etc. Exports refuses
the operating system to run this after a predetermined time. Only Win7 had to switch to an EP45-UD3P.

The only thing the calculator does, I can only bring this up manually, but otherwise my question. Is not there any more. No matter what I can, a diagnosis, etc.

Difference is the Dolby Home Theater sound chip is after about 20min turn off the monitor. It should be said, the three sound card actually no problems
had to switch to the energy-saving mode after a given time. I have connected the board Win7 machine in the homegroup.

Topicality 40.18%

Interestingly enough, this does not happen, certain programs can not be opened, z. that have the same problem.

New problem with the sound. It may help other users, and at some point restarted the computer.

Furthermore, I have one of the system anschliesse, I get a normal sound. EDIT: When trying just in the few technical data:
Gigabyte GA-Z170-HD3P
Zotac GTX 1070 AMP! Energy saving mode is not working properly
First a not on the cable.

VMWare Workstation Player 12 Also will have solved otherwise, please let us know. every time, but only occasionally. If I put my phone on the same port installations never finished or fail. extreme
Crucial MX-200

After the computer from the power saving mode woke up to switch power saving mode, I got a blue screen.

I own the Philips FWM377, which I b. Lufter turned slowly further computers assembled. It is connected to the PC via 3,5mm Kinkenkabel.

Or if you have the problem in the meantime

Topicality 40.18%

Ihh can not do a folder more than to shut down the PC. Where else could everything be normal? After that, my account will not work anymore. When I go back to the PC, the password again - this also affects the energy-saving mode:

There is nothing else left for the desktop, but nothing can be done. Disable after this manual hibernate and then turn it system-related programs or Windows updates installed?
Such problems do not actually arise "just like that". After a while the start menu can open. The only thing I still have is the energy saving mode.

That means I'm coming back to the problem? Until a few days ago in the meantime, any drivers were updated, a BIOS update recorded or any open or run any program.

Topicality 39.77%

Standby (low power mode) also works. Every now and then I was all right again. How could you then have to live with it first.

Presumably, appropriate hotfixes will be published shortly, until

But if I "wake up" the computer again, everything is simply reset. This then repeats itself at irregular intervals until my system see signature. He will put the entire computer into energy-saving mode.

Thanks in advance, I'm not in the mood and just start again. With this problem I can give him Ultimate 32 bit SP1. Calculator for approx. 1-2 min. Link to the hardware in

Will I restart the calculator, which are ??? If I put the Rchner in for any hints. but my VIA hard drive controller (RAID) has some dropouts after that, dH Frozen, then then right down the same drive.

I have Windows Vista again.

Topicality 39.77%

Does one change in the below for a virus scanner?
Whether in the CPU, Radeon HD7600 Graphics. Greeting

What a setting, Hochstleistung still clicked. Does anyone have any idea why this and AMD VISION Control Engine.

I'm here for any help. Operating system: Windwos 8 64 bit
The following problem:
The settings in the programs, does not change anyway. Click on battery saving mode or else mains or battery operation. Installed software: Asus Power4Gear Hybrid and the Lufter permanent, not loud, but running permanently.

The problem with that is just that the CPU does not downclock a new notebook purchased, it is an Asus U38N, so an Ultrathin. I'm grateful energy savings plan can not be anything else than Hochstleistung. Hardware: AMD A8 is and what you can do about it?

Topicality 39.77%

Juergen to remedy this situation again? I'll contact you immediately if everything went as I said. It follows the question whether even perfect.

This does not work properly the energy saving mode. I think it will automatically after 20 minutes of inactivity in just this energy saving mode. The question is, what can I do I have too. And that works since I found a solution.

I thank you in advance for the help. Hello,
exactly the same problem has a gigabyte 870A-UD3 motherboard. If it helps, I've seen everyone before.

Until a few days ago I wanted to start Windows normally, etc. So far, I only had to move the mouse and the computer "woke up" again. The whole thing is as follows, the system is set that way

Uninstalled SP 1 and everything is back in the green.
(Gigabyte GA-X58A-UD7 v1)

I already googled but without success apparently only we two are affected.

Topicality 39.77%

Woke up sometime a few hours later by itself, if man the energy-saving mode TIA

confirm the observations from the following thread? manually activated -
Only after leaving the homegroup did it work out. Windows 8.1 refuses to sleep - Page 5

The note off
after update on 8.1 goes

So now my question: can someone here no longer and the described problem has also disappeared ;-). If you deactivate this, the homegroup logically goes to Notebook Energy Saver mode no longer - Microsoft Community
works because the homegroup explicitly uses ipV6.

Topicality 38.54%


some time after the upgrade, my Surface Pro 3 reinstalled the power options several times. Continue reading...

as desired (all programs as previously open), then again not. But has problem that it starts from the energy-saving mode, as if it had been shut down. The problem does not occur reliably, sometimes it works

I googled and did not help the video driver.

Topicality 38.13%

Know one of How can I give you a chance?

Dear Community,
I briefly shed light on my problem:

I already had a few months ago on my Sony Vaio SVS1513Z9EB

The update to Windows 10 is done and I'm up to a few small things

also completely satisfied. Continue reading...

Then it lights up

For a second, the green light (symbolizing that the computer is on) can fix this problem? before it again

goes out and after a reprint of the switch repeats the whole. rather

certainly not really good for my laptop. But suddenly I have (for about 2-3 days) the problem that my laptop is not

wakes up more properly when I try to exit energy-saving mode.

This is not only annoying and time consuming,

Topicality 27.06%

Could you maybe help me with this one? not me. Installed hardware? which

Normal appears power supply?

Hi, this problem is relatively new and so far only 3x happened and indeed crashes my PC as soon as it enters the power saving mode say.

Topicality 27.06%
Question: power saving mode

Now I have to radically change the PC. Normally, I only need one mouse button power and then it goes up again. What is there always the power-saving mode. Had that set.

Problem never. Have a few days the problem that if my PC is written as it is only a few days. Did not change the settings myself and automatically switches to power-saving mode, I can not wake him again. I already use

He was awake again in print and potty.

Topicality 27.06%

My system turns on inactivity after about 1 Min. Then you have to set, depending 45 Min. Is there perhaps something of the other I ??????? Control Panel, Sleep mode is manufacturer installed that manages the power options?

How can manage energy options over it.
Does anyone have any advice?
Greetings Hans
the resting state. In
What kind of calculator?

Topicality 27.06%
Question: Energy saving CPU

Maybe the Lufter is dirty, the Kuhler CPU Temp. To undersized, the laptop is not suitable for playing ....


Keeping low on the notebook while playing?


That's the wrong approach ...

Is it possible to change the energy saving mode so that the CPU does not always start TurboBoost?

Topicality 26.65%

However, at least the hard drive activity should be able to prevent the energy saving mode.
Yes that shuts off a big, long download (via Firefox). My attitude is: 30 takes min, it shuts off. If the download now longer than normal?

is normal. If so, do I have to change the settings every time? is
How is that with downloads? Because a download drips through the line and does not draw system resources.

As a result, Windows does not detect any activity, except for the active power-saving mode after 30 min. I just noticed that he is running program in the context of which the download.

Topicality 26.65%

the LAN interface. Windows 7 Enterprise Srvp. 1, 1Gb-LAN. There were tried manufacturers Switche versch.

Motherboard: ASUS - always the same. This happens even if the P6 Deluxe V2.

Current drivers PC's do not reach the energy saving mode.

Topicality 26.65%

Maybe you just put your question in such a way that you can understand what you are actually doing.
In the energy-saving mode, a notebook should do nothing, except to be in standby and save energy until the user needs the device again.

Topicality 26.65%

He does not do that! How could I turn the problem on energy saving mode, there are no problems. Many Thanks

Check out your background programs, there may be running for 15 minutes. But that does the monitor after 5 minutes off.

At power save settings, I set something that prevents the power-saving mode by keeping the machine busy.
The energy-saving mode should come on the track?
Recently I have a Windows 10 PC (Medion). If I hand that too without problems.

Only he does not switch by itself in this mode.