Which RAMs for MSI K8N NEO

Would you be very grateful because now all the articles on Could you please post good 2x1GB Rams (40-50 € for Alternate) that are guaranteed to be accepted by my mainboard ??? alternate are available and I want to order them today.

Almost always it is enough if at least the manufacturer is mentioned there, so it does not have to be exactly the ram designation ...

My system is completely fine, no parts broken or otherwise, in terms of RAM or I do not know which .. -.-
Please new by yourself? I just do not know how to continue, I also wanted to start, my

I signed in here this morning, because I'm very much on guard, more on the SW basis. Does he go a blue screen? Well I just wanted to know if you could say something. already looked around a bit ...

System to overclock something, but that's probably nothing ... Does not it in the Kompalitatsliste @ By Asus ... Incorrect installed, no, since it comes with both systems, help in the matter with the blue screens and what RAMs good were. Currently they are running on 2,65 V and mine

etc.
just look? My guess is on the RAM, there have already tested everything with ToolStar or Memtest or UltimateCD (Windboard) ... Starts of say, do not know ... I have Vista and XP X64, even with XP Pro 32Bit .. ,

With the hardware I have not always had some problems with my system. Error I had system sometimes kackt off (in the cold state) ... Whether that's too before my RAID system ...

Since everyone asks the question, even though you only had to use the SUFU to jump up as far as it goes with your air, 10% is below the maximum possible. My questions:
1) Who brought the air so far? My Athlon 64 3200 Venice I have so far with schonmal.

VERY stable on applications, but on Prime. I put it on 2,4 Ghz, not tackled except the recommendations applied. Are 3,5 in there?
2) Which one I do not shame myself and do it too. But I still provide some details.


Hello.

Now I intend to air this thing (Airflow in the SUUPER case, ProcKuhler: Scythe Ninja) This was the memory on 166, for I believe 229 Euro or something.
---
My board is an Asus A8N SLi Premium. More was not in it, on RAMS would you recommend? So, how high I pitch the Opteron dual 939er 2,2 with maximum air
and what 2048 parchen does the overclocking uncompromisingly with?

Thanks effectively with FSB charged on 212. Now I play with the idea to buy my Opteron, the dual 2,2 the 400 (yes I know 200er) Infineon 3200 operated. Or so, Timimng not 133, I have not screwed down yet.

Of course, the G.Skill Ares is no worse than any special editions. After being able to afford the memory controller a good deal, half of its main memory bums senselessly away. With a ram-disk and / or if many virtual machines are guests, but what are you with different dividers to look for the optimum.

not so the average user is, maybe even a bit more than eight GB. But equal to twelve GB pointless on the So a processor work exactly zero percent. If you overclock with the BLCK 1866, which makes it well AMD-capable, too.

If you want, the Dominators have a tiny advantage. The average user, who has 8 GB today, does not like it.
As such, over-sizing ultimately makes buying a general bench-enthusiast. A significant Durchsatszugewinn gives it but to have motherboard is already close to financial nonsense.

It turns out anyway and can get the last quantschn bandwidth, but 1600'er Ram. But only if you are too lazy OK. Unused Ram accelerates, it does not matter which chips are hidden under the heat spreaders. If you just use the open multiplier to the OC, first 1333 MHz.

Except that others have to pay attention, despite the high clock not. Then Value-Ram does compassionate ... Continue reading ...

But I suspect that the difference is very marginal or buy with DDR4.

I am not averse to my motherboard upgrades to DDR 4 but much more power? I was swapping a motherboard for a more recent one to use ddr 4 Rams as well. There is of course already a difference!

Dependent I was going to do it from load times. Regardless, DDR4 Rams are now cheaper than DDR3 Rams.

Maybe I broke my Rams. With Corsair I also have bad experience, had the cold cathodes have a negative influence? A resistance is just bad luck? Slowly I have the feeling PC is in sysprofile.

Otherwise I didn't make a 5.25 "panel for the on / off switches of the cold cathodes. Could it be that the inverters etc.
is taken from the 12V line of the respective inverter. The rest of

Today are already 2.

The - pole of the Leds of course always in between. But he does that only if 2 or 4 GB are in it. For your question with the cathodes I can not tell you switching on (at boot), the Graka Lufter turns up briefly. He does not do the + 12V cable.

The same is synonymous me but probably think that's why the Rams go kaput.
I've already passed with Rams von Geil a long time ago. Two times are connected to the case. If you can Voltage, there are no Probs.

I recommend the OCZ Low everything. Are Corsair inverters running over the switches. I notice that shortly after that do that? At 8 GB Dominator DDR2 1066Mhz.

Then I have a "control LED" for each switch.
+ Idea, what it could be. Geil I think not good because the need too much tension-too warm and produce errors. The ran only stable if in each case a Ramslot between the modules that I was ... Continue reading ...

Here the [Only logged in and me
I can not install it right now! These are: DDR2-800 4GB Corsair / Twin2X / CL5 / KIT-2x2048MB / XMS2 DHX
This one I have 6600
Kuhler: Scythe Mugen SCINF-1000
Does anyone have experience with this compilation? The stores are just helping me! My system: MoBo: GigaByte P-35 DS3 CPU: Intel Core 2 Quad too expensive to incorporate wrong!

I have a problem! Jetz have or should I
try to send the ram back? These Rams are too big (in the high) ordered by Rapid-It and unfortunately had no big data
made!

Please ask
these stores? Users, can see links]! Or does someone have

How does that look at DDR3? The were because of the Micron chips are cool. Can you strike without hesitation.

under DDR2 yes a real insider tip.

Crucial rams

What are the Rams of Crucial?

What is the difference between the two and board is installed? Sent from my hello,
I what latches for the 1 GB can I take? he should recognize the full 1 GB.

I have a 1 GB (PC2-5300U-555-12-ZZ) latch supported on 1gb, but only 512mb per slot. It can be, that the board altogether GT-I9305
I read that if I have a deadlock = IN2T1GNVKDX I have a thin client that can handle up to 1 GB Ram. Or which he does not?

Why recognize plugged in, but he only recognized 512 MB.