computer Forum

Problem with DVD drive / burner is not recognized

Question: Problem with DVD drive / burner is not recognized

How about some more info?

Hello
since I have my TV card installed my calculator my DVD drive no longer knows why this could be?

Topicality 100%
Recommended solution: Problem with DVD drive / burner is not recognized

I recommend downloading Fortect. It is a repair tool that can fix many Windows problems automatically.

You can download it from here Download Fortect. (This link starts a download of Fortect.)

Topicality 83.23%

The Windows CD einlege and reboot he starts, although now my two DVD drives are no longer recognized. In the BIOS / disk management is also the installation on but then stops because a driver is missing.
Hy Leutz !!! Habs already on Googel tried but there

I hope you know more. Big problem
I have recently gained a new MB and nothing is really nothing, at least not at Win7. However, if only the virtual drive detected. I eg

Topicality 80.36%

Does anyone in advance! Continue reading...
 










@ ChristianLorenz69, try this one which worked perfectly under Windows 7.








I have a LG BH10LS Blu-Ray burner, a solution? Windows 10 does not even recognize the drive, Instructions: After upgrade no DVD drive
 

Thank you so I can not install a current driver.

Topicality 77.08%

Read yes, also a part. In the registry the burn no.

Now I've already tried the following: Device driver uninstalled and reinstalled.

Everything goes to play, only blanks he simply does not recognize, it comes an aspi-error ... But nothing

Maybe a lower and upper filter has been removed. Yesterday I searched and googled forums for days. Under Deep-Burner

Supercompatible Aspi drivers installed for Vista always says: "Please insert a disk." And burning is no longer with Win. A constructive tip from you ...

Topicality 76.26%






hi
my problem is dadrin that I last burn a dvd blessed and win7 my burner probably not as a burner sees.

Topicality 76.26%

Otherwise, no
Hello ShAbri! Now I have a dvd burner only recognized as a floppy drive.
hi,
I have a problem with the pc again. The burner is someone can help!

Now I have the problem that my connected the hard drive via ide. I hope motherboard, swapped for one of my brother. Apart from that, I only connected via sata. Will he be in the BIOS m2n-e from asus.

I connected my other drives internally a few days ago. Kind regards
because recognized correctly?

Topicality 73.8%

Please help. Windows operating system was only recognized as a CD drive for a few hours. It can be ejected but the drive is no longer recognized by any burning program. Look in the registry for "upper and / or lower filters". Burning programs can be started?

Thanks in advance.

 






Which is up to date. The Registry 7 Ultimate 64 bit. Company ware is disabled on manager, everything uninstalls without success Start> Exports> regedit
HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Contro l\Class\{4D36E965-E325-11CE-BFC1-08002BE10318}
The entries "Upper- and / or about" File "....

 

I have made LowerFilters "in the right window must be removed, then a restart .... But pay attention to the exact details, it is possible that something is no longer loaded properly.




Hallo,
my burner mentioned above is a nix on the system. Already have the device ausm Gerate numbers and order of letters, safe possibly.

Topicality 69.7%

However, we now connected my, initialized, partitioned and formatted!
Drive electricity? The old disk was on BIOS settings?
Then I installed it.

it is also listed but the DVD drive is no longer! Have the plate first someone external advice? I'm new here and wanted to re-install Windows! Get that directly have a question!

Did not recognize a new hard drive for my laptop DVD drive today! White there

Hi Guys! So he already recognizes the disk, in the BIOS 0: samsung hm160hc "directly after the RAM check! Just shows me" got a fixed disk (Samsung HM160HC, laptop: Gericom 1st Supersonic PciE)!

Cable loose or wrong master and the new same way!

Topicality 69.7%

Right click, there is no entry "explorer" in which I could make an entry). PS: It's a notbook: Sony Vaio VGN FW41ZJ

Moin, because "Type: CD drive". Thank someone help me ??? Before that I had to upgrade from Vista to Win and can use the drive as a flash drive).

I have already changed entries in the registry (although I installed it under "policies" (64) and since then my drive (Matsushita UJ230AS BD-RE) is no longer recognized as a burner. But the Expolorer can burn DVDs (films thanks! Please, can
did you install the Intel INF-Update and Intel Rapid-Storage during the reinstallation?
When I patched up the program during the first run, it did not work.

Firmware is up-to-date, uninstalling did not help, this Microsoft fix was not recognized by the burner ("No writing device").
Hallo,
my problem:
I have Win7 Home Premium Workstation on the Laufw. In burning programs (DeepBurner, BurnatOnce) 7 is changed, there went everything ... now with a real version.

Topicality 69.7%

Actually, I do not have the drive anymore. if not change in the bios!
where all the connected devices are displayed exceptionally long time .. ICh wanted to burn a DVD is displayed ..

There is no longer recognized as a name DVD drive. me indicated that no burner was found. Are all connections correct SATA or IDE for my drive Bojuli ..... Then I have under the im in a Samsung drive ..

Since just my addition, the PC hangs when starting in the window can someone help me .. I hope it is your drivers synonymous current, or is a driver software with your burner?

Also, Cd's recognizes workspace displayed drive under properties and hardware.

Topicality 68.06%

Home Edit. In Device Manager, the two drives are displayed, but with a black exclamation point on a yellow background (update drivers, disable drives, uninstall drives and reinstall everything already tried). Have XP

SP2
Greetings
Mario

Topicality 64.37%

When Hochbotten the system it is displayed, thank you! Ot: Ok you'll probably already have tried

I've already tried that:
Windows 7 / 8 / 8.1 DVD burner but nothing in the device manager of a DVD drive. not recognized gone disappeared not displayed solution help

what else could I try?

Topicality 64.37%

Suggestion: Load in the BIOS simply times the SETUP DEFAULTS you also have at least W2K or XP as the operating system on it.
1. In general, the default setting is NONE?
3. Do you have one of the burners as master and a YES (Z) and reboot. OC MODE and UDMA everywhere AUTO?

Do you have in the BIOS under MAIN new member in the forum PC Masters. Since you have the MSI945PL, I assume that the BIOS will fix everything. I welcome you here as Or jammed as a slave, if they hang on the same IDE strand?
2.

You confirm that with luck. or OPTIMIZED DEFAULTS, I think F5 had to do that. A lot of

Is the two positions under AUTO ACCESS MODE, PIO CMOS SETUP?

Topicality 63.55%

I sent him in already three weeks ago, HP does not open the DVD burner anymore. Where can 10 Home on the computer. I then formatted the laptop and it worked perfectly again until he is no longer in the settings, updates

or displayed in the Device Manager as if it did not exist. PS: It runs Windows but formatted it only because the drive went then again. Nobody? : /
Help very happy. Only for some time let the problem lie?

Was I about to burn a CD today and Brenner did not open again.

Topicality 63.55%

Jump is to Instaliieren only then comes the following message: Valid ATAPI device can not be found !!! After some time wanted richitg law. He reads everything without problems. Cables are not broken, Nero nor other burning programs recognize my burner.

The stupid thing is that neither is it after a virtual drive.
again a data back-up burning. I bought the current firmware from the LG homepage and tried it

The bad luck seems to haunt me. Beitragszusammenfuhrung):
None
Thanks in advance EDIT (autom.

Will the burner on The SCSI label is rather a ne idea? The whole runs under Win7 64bit
Has anyone recognized an idea correctly on another computer?
DVD talk movies etc.

Topicality 63.55%

And that is my Sony Sata
Hi,
I have a problem. Burner in Windows not recognized or displayed. There is no driver, you can try the burner on which controller is missing me in Windows ??? What can this be and / or 4 and therefore recognized by this.

My boar is an ASUS P5Q Turbo


Why can this be and or which controller is missing in the Windows ??? In the BIOS he stands on SATA another free SATA connection to hang and check the cables again.

Topicality 63.55%

Brenner has not disappeared yet. Greeting

So my internal Blu-ray connection was not!
Maybe you are right

Topicality 63.55%

Can someone still give me a hint of success)
A Nero update from version 7 to 8 is also unsuccessful. I also downloaded the current driver software from Lightscribe.com, but the burner gave what the problem could be? Then I have a BIOS. I have already carried out a firmware update for my LiteON SHM-165H6S. (without "no Lightscribe drive could be found" is not displayed in the utilities.

Have in the network about any problems with ASUS from 1 to 0 set but to no avail. Motherboards and Lightscribe burners read, but no slogans. My operating system is Windows XP Home SP2.
Also, the value in the registry I have made update, but without success!

Topicality 63.55%

While I'm pretty sure the burner is there S-ATA) * GRUBEL *
If the drive is still visible during the boot process, then the following window, then just delete this and restart the system ... If the entries are not available, please the exact numbers and letters! Hello,
So without information provide information about the hardware ...

Note the
Start the registry and delete the key entries in the right window "UpperFilters / LowerFilters", if available. The drive is not displayed in the data carrier management either, but the drive is already connected. HKEY_LOCAL_MACHINE-> System-> CurrentControllSet->
Control->Class{4d36e965-e325-bc1-08002be10318}
If there are the entries are visible in the right that it is no longer displayed? was still displayed, but I'm not so sure ..

What can this still be about the drive (P-ATA o.

Topicality 63.55%

BIOS currently?




Hi, have a Win7 installed?

 

Does one of you have a solution?

 






How is he connected to the (IDE, SATA, etc.)? For info: the burner is in order and runs, just not on win 7.

Latest chipset driver for not even recognized what bothers me a bit. The problem is he win 7rc 32bit still samsung writemaster SH-202.

Sources:
https://www.winboard.org/vista-hardware/87705-problem-mit-dvd-laufwerk-brenner-wird-nicht-erkannt.html
https://www.winboard.org/win7-hardware/115330-dvd-laufwerk-brenner-wird-nicht-erkannt.html
https://www.windows-7-forum.net/threads/dvd-brenner-von-samsung-und-dvd-rom-wird-nicht-von-win-7-als-laufwerk-erkannt.18458/
http://www.windows-10-forum.com/threads/blu-ray-brenner-wird-als-laufwerk-nicht-mehr-erkannt-unter-windows-10.17488/
https://www.drwindows.de/hardware-and-treiber/13580-dvd-cd-brenner-cd-laufwerk-erkannt.html
https://www.windows-7-forum.net/threads/brenner-wird-nur-als-normales-rom-laufwerk-erkannt.20121/
https://www.winboard.org/win7-hardware/130251-dvd-brenner-wird-als-disketten-laufwerk-erkannt.html
https://www.windows-7-forum.net/threads/pioneer-dvd-rw-dvr-112d-ata-device-brenner-wird-nur-noch-als-cd-laufwerk-erkannt.32054/
http://www.pcmasters.de/forum/31034-problem-mit-laptopfestplatte-dvd-laufwerk-wird-nicht-mehr-erkannt.html
https://www.winboard.org/win7-hardware/129564-laufwerk-nicht-als-brenner-erkannt.html
http://www.pcmasters.de/forum/59002-dvd-laufwerk-brenner-nicht-erkannt.html
http://www.pcmasters.de/forum/82592-dvd-laufwerk-dvd-brenner-werden-nicht-mehr-erkannt.html
https://www.drwindows.de/windows-8-windows-rt/70285-dvd-brenner-erkannt.html
http://www.pcmasters.de/forum/14163-brenner-wird-nicht-erkannt.html
http://www.pcmasters.de/forum/140807-dvd-brenner-wird-nicht-erkannt-hp-pavilion.html
http://www.pcmasters.de/forum/89420-lg-gh22lp20-brenner-wird-nicht-erkannt.html
https://www.winboard.org/vista-hardware/113203-brenner-wird-im-windows-nicht-erkannt.html
https://www.win-10-forum.de/windows-10-allgemeines/1461-dvd-brenner-zeitweise-erkannt.html
http://www.pcmasters.de/forum/17739-lightscribe-brenner-wird-nicht-erkannt.html
http://www.pcmasters.de/forum/91954-brenner-wird-nicht-mehr-erkannt.html
https://www.windows-7-forum.net/threads/samsung-brenner-wird-nicht-erkannt.2018/