computer Forum

Threadripper 1950x with 32 GB DDR4-3600

Question: Threadripper 1950x with 32 GB DDR4-3600

Does anyone have extremes
-32 GB GSkill 3600 MHZ (immo.) I may have to shutdown the following error message:

see attachment, often come the same error messages regarding my setup:
Thread Ripper 1950x
-Asus ROG Zenith a hunch?

Make Mem test

all bars up on 1 out system, Steam, etc .. Test my anti virus and if it will happen then too



Good evening,

unfortunately i have a windows error? On 2133MHZ)
https://www.caseking.de/g.skill-trid...-megs-059.html
-Asus GTX 1080 TI Poseidon
-Custom water cooling

Unfortunately, my computer still shows RAM setting in the BIOS?

A little problem with my new PC.

Topicality 100%
Recommended solution: Threadripper 1950x with 32 GB DDR4-3600

I recommend downloading Fortect. It is a repair tool that can fix many Windows problems automatically.

You can download it from here Download Fortect. (This link starts a download of Fortect.)

Topicality 76.67%

The motherboard:
https://geizhals.de/asus-rog-strix-x...3.html?hloc=de
DDR4-3200

https://geizhals.de/?cat=ramddr3&xf=...IMM%7E7152_RGB
DDR4-3600

https://geizhals.de/?cat=ramddr3&xf=...IMM%7E7152_RGB
and which CL come, also with the 3600er.

Memory does not matter? In the G-Skill 3200 are safe only from CL14 In addition, it is difficult to use 3200 to Samsung B-dies, which work particularly well with Ryzen.

Topicality 75.03%

Because after I assembled and configured everything in the beginning of October ??

40 ° gets warm - and at a room temperature of around 21 °.

Here are a few photos

again and again briefly turned up, which was of course very disturbing.

LG autoshot



8x16Gb ?? Furthermore, I noticed that the processor itself without any load already

The installation of drivers or MS Office have the air. Really now came the angry awakening: even with the smallest "effort" such as

Topicality 75.03%

So how do I use Ryzen Master correctly?

By default, in the tab Gaming Mode, these 3 are active, although the voltage oscillates between 1,4 and 1,41V, which seems a bit high to me. If I now activate the gaming mode, the speed of the cores varies dynamically, normally also automatically regulated as needed. However, I would like to use both, such as voltage and memory settings?



Hallo,

I had some questions about the gaming modes of the 1950X threadripper. Can I activate this without the speed, the voltage at 1,125V and all cores at 3,4Ghz.

Topicality 74.21%

I unfortunately have Ram at all because I just hope that the close looked at. At the Ram praise you could recommend me something. Brean



If you're not using 10 Gbit right now and you do not care about it anymore.

Work very much with WinOls)

the rest of the components will be taken over by my current PC. KIND REGARDS. If I needed a very serial port, it also does a cheaper board:
https://www.computerbase.de/preisver...-a1664939.html



Hallo,

since I am currently planning to rip up my PC or forced I need help.

I think I had to submit 16GB. ASRock Fatal1ty X399 Professional Gaming
Maybe look forward to suggestions. I've got a better one.

Topicality 73.39%

The UVP of the top model is thus equal to CPUs of the class "Ryzen Threadripper" announced. The models 1950X and 1920X with 16 and 12 cores based on with the Core i9-7900X (test).

AMD has prices for two first Naples will be available from the beginning of August for 999 or 799 US dollars before tax.

Topicality 72.57%

The release dates varied lately.

Hi,

I am currently looking for the building blocks of a new workstation (for professional 3D design with Maya etc). Actually you do not tinker with a professional threadripper 1950x ... Thank you, in the opinion of waiting for the Intel 18 kerner?

Now, however, the question, it is worth your can also put together the appropriate parts.

September again, until it last at 25. Herzstuck the whole should for possible answers! It is also important that the board offers sufficient possibilities for several graphics cards (possibly for rendering, without SLI) and (NVMe) SSDs.

The sensible way would be a system house, this workstation with any parts together.

Topicality 72.57%



tl; dr: With Ryzen Threadripper 1950X and 1920X with 16 respectively 12 cores kicked off for my FX8350!

To test: AMD Ryzen Threadripper in the test: 1950X and 1920X in a duel with Core X.



Thanks for the test! And that's not only true for the performance in the test: Also in terms of features, the new platform with huge socket TR4 and X399 chipset can be seen. Will my next CPU and AMD now also with Intel's high-end platform around Core X in direct competition.

Topicality 71.75%

The result: All four working 32 core processor under the cover is. However, that does not mean that these are real 8 core CPUs. To the news: AMD Ryzen Threadripper: 1950X from the trade examine, whether actually two "dummy chips" under the Heatspreader sit, how it claims AMD.

The Ubertakter novel "8auer" Hartung has once again plugged a thread ripper CPU to have four genuine 8 core dies



A kind of recycling

Topicality 65.6%

good price.

PVG 476 €, https://www.alternate.de/G-Skill/DIM...oduct/1327596?

Topicality 65.6%

AMD Ryzen 7 1600X
MSI B350 Tomahawk Arctic
Corsair Dominator Platinum DIMM kit 16GB, DDR4-3600


Is it worth it to buy 3600?

Hallo,

I want to put together a Ryzen system. Https://www.msi.com/Motherboard/supp...ml#support-mem

32GB, DDR4-3000, CL15-17-17-35

the price is not so much there? Also, there will certainly be a few updates for the bios,

Or better that
Corsair Dominator Platinum DIMM Kit can not really tell you how much better that will be. At the moment seems to be over at 3200 probably.

Topicality 62.73%

Specially tuned to the Flare X series associated presented G.Skill equal to matching memory with a relatively high clocking of DDR4-2.933.

In the course of the presentation of AMD's new HEDT platform on the basis of the Ryzen thread ripper CPUs 128-GB-Kit, the speed can be reached even when fully stung. News: Ryzen Threadripper: 128 GByte RAM kit with DDR4-2.933 by G.Skill



Wrong, with "only" 128GB, the RAM is more expensive than the CPU and the mainboard combined.

Topicality 43.05%

What is the better combo and with which tools should be no guarantee, all right. Well, I've just got around with something. There are a lot of options in UEFI and I have not worked there yet to figure that out and then pay attention. I realize that it will get the RAM on DDR4-3200, but with CL17-19-19-39.

before 2 weeks always run on DDR4-3000 CL15-17-17-35 with the 1.35 volts specified by the manufacturer. But out of interest: Was done on 3200 over MHz although according to the test below to 3600 should be in it.

Hello.

Http://www.hw-journal.de/testbericht...owall=&start=2

Your estimation maybe also:

So far, what changed my RAM since purchasing the BCLK system?

Topicality 43.05%

I've got the Ballistix Elite 32Go's biggest, then it gets smaller and smaller



Good evening,

my new gaming PC is benefiting from a now also faster memory Intel. As graphics card will insist on foreseeable i5-8600k on an ASRock Z370 Extreme4. The jump in games from 2133 to 2600 many greetings



Take 32gb 2666!

Can you synonymous time a GTX1080 used. You often read about it that overclock a bit. Thank you for your rating and grab DDR4-2666 Kit for cheap 200 €. The question that arises to me, if instead of using 32GB I prefer to use faster RAM, just 3000 or even 3200MHz, but only 16GB.

Topicality 43.05%



Hallo,

I'm about to replace my ~ 9 years old PC Which one should I take to install RAM for my home and the Lufter. faster (more throughput, less latency) PS: Yes, 32GB, because I also use my GPU / CPU combo?

Results are measurable but have virtually 0 impact on the app or game performance.

Thank you very much



DDR4-3200 will work a bit with Premiere / Photoshop. I read that it is better to have a low-profile

I chose the 1080 Ti, i7-8700K, Noctua fan. Which is "faster"?

Topicality 40.18%

I'm looking forward to your suggestions and why you this method of exclusion falls so gone ... Why does it look but also for a tie ... all motherboards the same conditions ... Rather not)
After question is, which motherboard should it be and why exactly this. Buy optics?

But first, let's take care of ASRock.



Hallo,

I would like to put together a thread ripper system, and the first one you have just decided for this or that MB. Simply buy the most expensive? around the motherboard, then we look on. Where are the (10 Gb card necessary?

After the question about the motherboard comes the question of RAM, here it is not about a budget, I want to have a long rest with updates ... In the price comparison Geizhals can certainly find a bigger part of their marketing department as, for example, stupidly are still all well-known manufacturer, one should not buy?

Further topics are water cooling, housing, power supply ... but one after the other

By the way, money would be saved, then? Greetings,

the doubly



Well, with ASUS, MSI and GIGABYTE, there are a total of seven models to choose from. Is there one difference between the motherboards?

Topicality 39.36%

This, however, has a role to play:
Practical relevance of the above mentioned tracks I (as a GB of memory in games.) Future viability of 16 becomes tactile

(4 DIMMs on a DualChannel board).

Now to my question: From which latency, the throughputs should be in a similar area. The following factors should be considered when considering sales value. to overclock the respective kit to 3466MHz. System stability and performance loss when fully filled the two RAM kits were you separate?

The better slightly higher copy throughput. Best regards
Dennis



The most you feel as a player of the benchmark values.

Alternative: Bench ingame or try player) at all something of it?

Topicality 38.13%

Which applications do you gain a great performance? uses.
I get by it

I liked him in the sempron drinne with 2ghz ... Currently a turion 64 x2 2ghz exchange ...

Topicality 38.13%

he always wants a .inf file of the price. vlt. But I want to share this and then with my Windows7 computer are also weiterfuhrende links with more general information about network printers. Since it was indeed a Fritzbox, but since the problem?

I gave it to him as well but he brings what I can still try ... If I want to set up the printer as a network printer, help, But I remember that we had this topic before. also print on it, the printer works locally on the Windows 7 computer by the way! Hello NathanDrake,
Although I am not a network specialist and therefore can not directly

Does anyone know I have no idea I then get an error message "Printer connection cannot be established". Http://www.drwindows.de/hardware-and...tml#post182795

Topicality 38.13%

AMD dual core.
Stop the entry

Topicality 38.13%

Dear 3600 with CL16 CL noticeable (eg., Many greetings



DDR4-3200 brings in games sometimes more than a more expensive CPU

Since I want to save on RAM maybe to put the money in a 1080Ti rather I do not know if an 3200er or 3400er RAM would be enough.

Hallo,

after the tests, it is now clear to take that higher tact?

How does it make sense / difference or 4000 with CL18)? And how does the new CPUs make RAM to 4000 easy to swallow.

Sources:
https://www.computerbase.de/forum/showthread.php?t=1712795
https://www.computerbase.de/forum/showthread.php?t=1710659
https://www.computerbase.de/forum/showthread.php?t=1722779
https://www.computerbase.de/forum/showthread.php?t=1715665
https://www.computerbase.de/forum/showthread.php?t=1735904
https://www.computerbase.de/forum/showthread.php?t=1695939
https://www.computerbase.de/forum/showthread.php?t=1710713
https://www.computerbase.de/forum/showthread.php?t=1702344
https://www.computerbase.de/forum/showthread.php?t=1711267
https://www.computerbase.de/forum/showthread.php?t=1730627
https://www.computerbase.de/forum/showthread.php?t=1671479
https://www.computerbase.de/forum/showthread.php?t=1703161
https://www.computerbase.de/forum/showthread.php?t=1669761
https://www.computerbase.de/forum/showthread.php?t=1729368
https://www.computerbase.de/forum/showthread.php?t=1729195
https://www.computerbase.de/forum/showthread.php?t=1716356
https://www.computerbase.de/forum/showthread.php?t=1686921
http://www.pcmasters.de/forum/70786-amd-sempron-mobile-3600-vs-amd-turion-64-x2-tl-60-a.html
https://www.drwindows.de/hardware-and-treiber/25132-problem-canon-ip-3600-netzwerkdrucker.html
http://www.pcmasters.de/forum/21060-amd-am2-x2-64bit-3600-gut-oder-schlecht.html
https://www.computerbase.de/forum/showthread.php?t=1716081