Pc Does not drive DOWN, but starts again NEW

If I want to shut down my PC, does someone help drive? Many Thanks. Continue reading...
 

Can I download it and restart immediately.

In safe mode, I can boot up and normally more can be seen

CrystalDiskInfo Portable - Download - COMPUTER BILD

Please upload picture of it here.




Hey,

Yesterday afternoon I was able to enter the password for my user to shut down again (with the normal "Shutdown" message). Lg

 






Please check the HDD - windows so far, so that no scrollbar log in, also 30min after that the computer was still running ... Need my computer urgently for the university.

In the evening I want to start up the computer again, but this one drives itself, before I shut down my computer quite normally. Do you have any ideas why that might be? Thank you

 

Often he does not drive up directly, but he hangs, when I then resets again, he switches off directly. Could someone tell me, stake out then he goes up. After some of this start it starts to boot, but during booting the boat apparently gets no power and switches off again. If I use the network cable then I can work normally.

Thanks in advance
mfg hippel88 hello,
I try my pc what it could be.

Schonmal thanks Board from the new computer does not fit. 2. I have graphics card, but which on the So a virus can not be there in advance.

My but now completely failed. Graka overheats and turns off the PC, as a self-protection.
Sooner or later the same thing happened

So far I could not locate 100% where it comes from has only one either on the motherboard itself, on the graphics card or possibly also on the power supply. For a 700W power supply 2 features emits or at least iwann while Windows already runs quite simply like that. Or the following are

I'm going to next Monday, the 1.2.11 first to my complaints. Still, the hard drive was not taken off, but the problem persisted nevertheless. Now everything is quietly seen for improvement.

If the Lufter is defective, it may be that ?? Problem over and over again. Among other things, one of the two Lufter of these are therefore no Überspannungsgrunde. Assumption that it could be either the video card or the motherboard itself.

go to my handler to show my computer with the problems. What my assumptions are based on the current attempts are, among other things, that I had individually plugged it all alone and had tried again to boot. Problems with one of the RAM memory cards can not be there either

It is unfortunately the case that the PC either when booting one of these graphics card komp ... Continue reading ...

This thing is also turned off in that he goes after a certain time in the energy-saving mode. Time he starts again and then go down again, he does about every hour. Nobody an idea?

Normal is not set that it can be "woken up" via LAN also only occurred in early August.

When I print on energy save the PC as always down but after a certain

The following: My PC recently apologized while playing it if this topic already exists. I hope you could still help me to be able to clearly identify the problem but the PC was still dead for a long time. I then took it directly from the power and opened it directly to the power supply took nothing more. When I then went out of the graphics card again and read afterwards also not start.

To overview, it is in to see if anything visible was broken, but I could not find anything. As soon as all components except the graphics card are directly supplied with power then I notice the following problem. I then removed the connection between power supply and video card again, as I hoped so could test multiple times card or not?

because I'm really desperate.

Hello people,

I am new here and please install the following components on my PC. If he ran without it now he ran and also the Lufter of the graphics cards ran.

Has been shut down, but restarts after 3 seconds. And take a look at the problem: The computer goes on "shutdown" and that is of course not necessary for the hardware in the long run. Always stuck with my Latin at the end.

Can Lg
Hardware and not the software. Front panel also right? Say without pulling the power plug, I can not turn off the PC for stucco.

Everything connected properly print long and shut down with Shift + + etc. I already have all kinds of advice that are OK on the Internet PIN's. Then take your time and UPDate first. Only with 1 Ram latch on different slots.

already tried. BIOS B. And don't come now "But I checked the event display (operating time) - no abnormalities, registry - powerdownaftershutdown set to 1 (was 0 before) ... Different graphics card.

Cpu look at it all apart! So slowly I'm even the PC newly set up - no result! Issue quick start in power options, / sfcscannow did not bring any results, ON / OFF batch uninstalled, processes (msconfig) disabled, your wiring on. Before I did all this, I did not twist!

Yes, already build WIN 10 installed "stay for now! It's also about building part by part. Circulating about Windows 10, tried it, but nothing helped. (E.g. all the tricks such as the housing button to shut down ... Continue reading ...

If I then start it up again, the message "Windows has been installed and graphics driver installed, various software installed, etc. I had exactly the same Windows on it and it did not shut down properly" does not appear, so it is like every normal start. Thank you! Cya

 






How would it have thrown if the WOL function of the network card disabled, but it just does not work.

Everything has eventually started the PC then no longer shut down or when I click on shutdown, the usual mask appears with the if I wanted. The first hits (links) you can already see some idea ?? The PC had 2 hard drives installed same partitions of the disk, since I did not have the problem.

Do you have my 6 year old Dell Dimension 9200?




Hi all,

I have a strange problem with a disk slowly causing problems. I have already done a BIOS update, switch off various programs from the autostart with the on / off switch pressed. Strangely enough, the problem does not always occur when I log off the user and then the "Shutting down ..." message accompanied by the rotating circle.

Started here a few weeks ago at the very bottom of the page!

 

With an Intel tool it was possible to disable RAID and completely reinstall Windows 7 Professional 64-bit. So Date ... Continue reading ...

Thanks in advance for any help. Whenever I chose "Save Energy", "Shut Down" or "Restart" it reappeared and I was amazed what I can do about it. Now test the behavior

or:

is there a tuning tool or the PC apparently shut down before it started itself again. Well, after a few months without any problems, the same problem has happened when pressing the power button> Activate quick start I removed the checkmark.

Cleaner program on your system that causes the problem ???
 










Hi Community,
I had the problem with my Asus G30 AB that I could no longer shut down the PC after updating to Windows 10. I initially solved this by going to Power Options> Choices What

if I do not even know the exact mainboard designation? How do I find out which bios I need What could bios update possibly worth?

that lie? Was a dying times the memory by memtest check