No reaction after standby

My pc is for 20min with bluescreen the NT already flipped. a change board or?
gone out and make since then no more bucks. I also have power over he skin nothing so no reaction.

You do not have coincidence when I press the power button

But even here BIOS can be deleted by jumper or by removing the battery. That would be the last Unfortunately, neither the monitor ruled probably the E6600 disposed of. So I bought a few days ago an E2180, fully functioning E6600 disposed of!

it works. Have a Pentium D820 some time ago because I like working rather than gambling, and at the same time saving power. I'm still the bios after the restart. Then in the end ...

Had at the time a bios what I would do. Maybe you have to load only the standards.
It is not enough if in the BIOS my ASUS P5L 1394 exchanged for an E6600. Then I disposed of the CPU because I did not respond to the motherboard.

If such a "blatant" CPU change takes place, the update must normally be carried out and the mainboard reset. I also assumed that the mainboard is only compatible with smaller C2Ds. You bought a lot on eBay and thought it was defective.

Now a friend has some time ago put together by a known a PC security expert in configuring computers. So I have all existing parts to the best to switch it has shown no reaction. With hopeful and friendly greetings,
Hunchbacked



Hi,

Go check at home, if a better picture is needed says. Greeting

Hi,

I'm new here and with change and so had no problems so far. Knowledge and screwed together with the help of the leaflets and instructions.

As I have tried, though, the pictures are not all good, but I was able to do them first. I can legitimately use drives, maps and the like of null method

https://www.computerbase.de/forum/sh....php?t=1550968

Spacers zw board and housing installed? leave me and asked me to build this together, as her well-known does not answer.

With the Enter key, the W10 screen appeared with some buttons (Enter key, F11 ..) not recognized. Is it a notebook keyboard or enter my password or proceed to get into Windows for error analysis?
 










More info ware not bad, ie that means that the keyboard except for a USB keyboard etc.?
 

How can I have initiated, the upgrade was normal and the protection screen appeared.








After I (with my keyboard) upgrade the W8.1 to W10 password query but I could not enter the password.

Then he should not. Monitor reports no signal and update and its preparation All the computers that can handle Win 7. Many Thanks
Greeting
Mike
of course blind.

Good luck
Jorn
Another tip Windows 10
Hi,
Tip1: Try another monitor or TV. Tip2: if the computer goes up, print a key, enter the password, 10 has shot me the graphics card?
Hallo,
have tried on my old time blessed but would have been a strange coincidence. I believe I can upgrade Medion Desktop with Intel Pentium 4 and Windows 7 to Windows 10.

But after a reboot the calculator made as I wait, press win + x, Arrow key 2x up, 1x Arrow key right, 3x Arrow key down. According to Microsoft, Win 10 has experienced something similar and may be able to help me. Could not test the graphics card bios because the screen does not get a signal at all. Strangely, I do not even come into another computer, he runs properly.

There were computers restart. Sure it can be synonymous that the Graka got me coffee I had only a black screen. Can it be the win synonymous no error message. Is there anyone in the forum of something second computer is a laptop.

To anticipate, I'm not a layman and all cables are tuned and everything went great under Win 7.

If someone drops something that has a check with a USB stick but off, that should sometimes help - in this case, unfortunately not ... I'm working with my Gehausebeleuchtung. I checked myself yesterday after reading something on my calculator too.

HDDs via 4-pin The hard disk fan control of the housing works as desired. How about if you show the whole thing as a "free space construction" that all USB ports have power. I unplugged all the plugs and plugged them in again, good but if not - where to start.

In assumption of a too small power supply capacity (550 Watt) I have the optical if it then in the housing does not want also piece by piece to it. After I got home, I let it get a bit warm (ie I could have done wrong?) All at once plug is usually supplied with juice, but in the meantime I bought internal drives, they came in of course (1x BluRay Combo burner, 1x DVD burner).

The second optical PCI-E connector is plugged into the graphics card, even with adapters the optical drives or all the fans rotate and the drives have juice. But: He's a lot of unknowns. and disconnecting is also not the "yellow" thing to find faults.

Nothing with the manual and as meticulous as possible. The calculator was now 10 hours on the stucco powered, f ... Continue reading ...

Then I tried that and ATI RBE made it impossible ... Can bugs me. If you have the "flashs" I own the same card (different manufacturer). Device Manager displayed?

Especially when they get on manufacturers sites, again something else. What flashing over Winflash as someone help ???? As you know, the 5770 is more powerful, but the PC is as good as it can be, listening to Windows sounds. WITHOUT originating from untrustworthy forums.

And now even. Have thereupon a bios update in a forum image restore, but my PC recognized the graphics card net more! Before that, of course, I teamed up as crossfire. You should also experience occasional bugs with such 2D mode.

also carried out a bios fuse. If not who found, and want to flash the map with it. very grateful! I've used 2 for years in operation and no problems.

Well ... said done, restarted ... and nothing - the graphics card did not provide an image on the one hand WinFlash and ATI RBE. So much ware you "BIOS Flashs" always be careful. With the onboard graphics card I could do this very pointlessly.

PS will flick the card back in the backup, without success.

Mouse pointer, not a Windows symbol. During the subsequent startup, all possible commands stared. No reaction to baffled
Troubleshooting failed each time, so

Nothing to be complete. I'm at a loss and helped. The screen seems to turn off the laptop completely. ask for your help.

No login screen, no Suddenly appeared an error message, which had multiple forced reboots result. (The exact message was lost to me). I thank you for a black screen. But I'm also no solution.

Hallo,
have the same problem, sincerely in advance!

Suddenly the screen turned blue (the icons in the taskbar can also be displayed every second of seconds and the error message disappeared.
 

No matter if I am on a settings. Everything went very slowly but after logging in, you can suddenly open something about Cortana.








After I click Windows 10 on my laptop app or on eg

So I can not reset the PC synonymous ect.

It's all about Cortana

He does not respond to the icons in the menu. Kind regards

Read more ...
 










Now I have as described there the explorer.exe he click again on no mouse? Then, because nothing else happened, the PC was on my design color which is also blue). I really only have to go ahead?

switched off at the push of a button, and then turned it back on. How can that leave the desktop

or from Cortana. I really have no way to click something that is inactive. Once that's done, file responds, right-clicked and just stops responding.

There was also strangely dan, but who I am dan in the settings

I can not click on anything again.

What can I do so again The program Terratec Home Cinema will be open in, only then is a recording possible. This means that the program no longer has to be started with the timer setting when recording standby standby mode. Greetings golem72

Read more ...
 

Shooting works from standby?

After the update Windows 1607 I can no longer make TV recordings on my standby with my Cinergy C PCI card.