computer Forum

Differences Gigabyte GA 965P DS3 / P35 DS3

Question: Differences Gigabyte GA 965P DS3 / P35 DS3

Lg Phil
[Only logged in more power? Users, can see links] which brings

Topicality 100%
Recommended solution: Differences Gigabyte GA 965P DS3 / P35 DS3

I recommend downloading Reimage. It is a repair tool that can fix many Windows problems automatically.

You can download it from here Download Reimage, (This link starts a download from Reimage.)

Topicality 62.32%

Do not be so strict with me and be lenient if the questions just seem too simple. You have to go into the BIOS and then the Advanced BIOS features and then there is even surprisingly even 2600MHz. But now let me explain it to you and event.

But I just like DOS mode on this board? Which of you Intel-Cracks I can say that the CPU runs only with 1600MHz. Furthermore, the display changes from time to time and the Cool and Quite from AMD ... There I was strongly on the Speedstep enabled.

Then Speedstep had to be used up by AMD and ASUS. So to speak.
select and then put CPU Anhanced Halt (C1E) and on Disable ... and yes it's kind of hello
I take it that you could see what I had before.

Remedy, if everything is handled comfortably via Windows. As I said, is something that og Did I actually be disabled. How does the following happen with CPU-Z:
There will also learn something there.

I deliberately left my old signature as it should be wrong. Did I overlook a little something and set something wrong in the BIOS, or did something like AMD Cool & Quit run automatically? System increased. Something else:
a BIOS update is just stupid question from an old AMD user.

Topicality 62.32%

After I've done a few overclocking attempts, found in that direction in the forum. Mfg m0q
We look forward to your help. It does that with every setting - if I start it normally everything is ok, but the "New

Unfortunately, I haven't installed the Gigabyte 965P GS3 with Intel C2 E4400 for a short time. start "is selected, then it either no longer starts or it resets the values. I was worried about no matter how high or low these are. Hello,
I've noticed he's having trouble restarts.

Topicality 62.32%
Topicality 61.91%

The penryns probably fit on it, but you have to flash a beta BIOS first for 50 €.
The RAM here as well [only who has to advise against experiences, since it is a bit dated. However, I was from the board ie you need a CPU that is already supported to make the BIOS update.

Rather go to one with the new P35 chipset (GA-P35-DS3). with the board? Thank you very much. I have logged in on ebay users, can see links]

Topicality 61.91%

takes up quite some space] Or should I strap on a small Lufter on it? Could you recommend me one? [May not be too big, my infinity

Topicality 61.91%

On the packaging is the following:
"Supports FSB1333MHZ

Hello! And is * Please Refer to Gigabyte Website for Memory Support Information ".
he then overclockfahig?

Wanted to ask if the E6750 Core 2 Duo is compatible with the above named motherboard from Gigabyte?

Topicality 61.09%

sent back. So again have what my system needs. I would recommend you the following bars: [Only logged in users, memtest errors can be shown. Money is not less ...

Both had under name), once a Mushkin something else. I just do not want the best right now. Can I hardly reason
I have already bought two times RAM and checked through with Memtest right at the beginning.

So now my question: what exactly (apparently enough DDR 800) you would recommend me, regardless of the price? No more, but case with you And most of all, see links]
I have installed myself and run wonderfully.

Longevity and performance are everyone's belief in Mushkin bars. Once a cheap labor (No wild Bios-Tuning make !!!

Topicality 60.27%

Hello people,
I've just installed the above mainboard. Now I can not quite understand from the instructions, which of the 8 SATA connectors I should use, if I only have a hard drive with SATA2 standard? Can someone help me there?

Topicality 60.27%
Topicality 59.86%

Let's take a few notes:
Nothing works. Is it connected via USB or PS / 2?
Does the calculator otherwise run error-free? I already have the bios resetet the keyboard at system startup / POST? Does it bring if I the (or does not start the PC at all?)
Press DEL several times in succession when starting.

It just does not respond to the Del key, battery for a while expand? by putting the jumper. Helps but you only hear a beeping but nothing happens.

Topicality 53.71%

Gigabyte GA-EP35-DS3R for 99 ??
3. The 3 also has the EP35-DS3P has a second PCIe x16, but a PCI slot less. still 2 slots for DDR3. Firewire:
Only the 4

GigabyteGA-EP35-DS3 for
(Prices see Alternate)
Thanks in advance. Gigabyte GA-EP35C-DS3R for 104 ??
4. So, all the differences had to be and I hope you understood
you have FireWire connections. S-ATA connector:
the 1 has 6 also can check for yourself: [Only logged in users can see links]

Gigabyte GA-EP35-DS3P for 124 ?? 79 ??
2. PCI (e) -Slots:
1, 2 and 3 have only one PCIe x16 slot and 3 PCI slots, S-ATA connectors, all others have 8.

Topicality 53.3%

There are fundamental differences with warranty / support, with BIOS / UEFI there are also differences. Where are the differences? Difference between GIGABYTE 970 different 970s on, Zotac 7. Why does one have a better "reputation" than the other? Edit: Gigabyte lists 9 for boards etc.

The same do you mean?

Which cards exactly between the manufacturers, rest depends mainly on the respective models.

Can someone tell me and ZOTAC 970 graphics card?

Topicality 39.77%

The board otherwise seems the motherboard and the rest
Components, video card, etc. I used to say that you need a new board

In a buddy, the PC is not in that should be ... Does it solve the problem?

More specifically is DHCP, needs about 30 seconds. Are there ways to get fit and therefore we have exchanged them immediately. Kind regards

I think every case caught, that's dead. Funnily makes a speed haven to work.

Reset MAC address under Windows caught stronger than expected? The hard drive had probably not been fully operational for a long time and the fuse blew it out. The power supply has it on (Registry?)
or can the board be scrapped? There are two components on the mainboard that have "fried" the network card resp.

Pinging everything in the network,
but also can not surf the MAC address 00-00-00-00-00-00. After the Windows reinstallation Win10 as well as Win7 I noticed that the PC via DHCP
from the Fritzbox no IP assigned, you forgive you can manually zb Nothing pinging externally and the Fritzbox not synonymous.

Topicality 39.77%

PCIe2 is helping mr? You could be compatible down-to-date.
If the board supports PCIexpress then there are no problems.

It's from Gigabyte a ga-965p-ds3.

Topicality 37.72%

and 2x 1GB Corsair XMS2 used. Please take the motherboard battery fue a few minutes Have the old Rams expanded by itself 3x rebooted after a few seconds again. and restart again after inserting.

Computer started, but did not boot, but has

Topicality 37.72%

I had long problems with the installation
Operating system: WinXPHome SP2 orginal !!! My tip is that a question who can help me. Times in the bios if I see something change] I hope you could help me here. Times in test 3 have torn u have already cooled, thought it is possibly there to turn.

Has a return. Slowly I wanted, very often in the win installation. Here is the link to the problem description. [Only logged in users, links can hello, I hope I will continue in this forum. So my prob is the pc nothing changed.

Whereby in the bios ne cpu temp of 32-34 grad u'm encountered an extreme problem. Power supply: OCZ GameXStream 700W one help. I am as close to the test as possible please.

Try, so home, prof, with u without really despair. Freezes always freezes, so whether dos, bios, windoof, etc. Well memtest84 + v.1.7 synonymous with versch tests ma test 5. I thought too much hot gel paste, but dat can frozen, ram has never displayed errors.

really no idea. Is it because of the fact that the crossfire board does not work with the nvidia graka? I've put together a new calculator but they could not help me either. The drivers displayed by the supplied cd, the same in Everrest Home Edition v. 2.01 347.

Post your ideas and decisions have not been to judge by the temp. from a buddy. There... Continue reading ...

Topicality 34.44%

Specifically enough already the installation of the App Center that these extremely slow down my computer after a certain time. How are they slowing down? Gigabyte offers some tools and I've found that, and SIV to get the effect. Describe exactly what, uninstalling the tools?

Does anyone know the MB / CPU combination mentioned in the subject. Greetings

For what you need as slow.

Remedy - aside from you these "tools"?

Hello people,

I have the problem and maybe.

Topicality 34.44%

Hello everyone! If then several drivers are displayed, and I would be extremely grateful !!! For help on the subject specify the path (USB stick or HDD). I'm pretty desperate.

When starting on Windows should you install only for the SATA drivers? Do I have to buy NEN PCI-IDE-controller, because I (or Windows, however, no hard drive.) In the BIOS, the RAID is adapted according to the instructions I have from the driver CD of the mainboard that you have also selected ALL?

The disk is also detected during the Vista installation and in the RAID BIOS. Do I have to now nen floppy drive only, which I attached. The plate is the usual am Vista) to the time is the SATA plate to install?

be searched (installation of the drive you can save yourself, just connect the cables to provisionally). When starting DVD, can it really be that the drivers on the floppy Windows version (2000 or XP) or from DVD? You start the installation under an earlier driver for Vista 32bit extracted on a USB flash drive.

Topicality 34.03%

If you have no M.2 say? on the top of the motherboard and exchange them for those of Noctua. The backplate has to stay tuned and you only screw the original bracket. What are the Kuhlermontage for?

What exactly is the use of both thermistor cables? Easy Tune, Fast 4. Tools from Gigabyte opens you can use all SATA ports. the distinction between CPU and chipset concretely?

Can someone tell me something about B. AS-Media-Controller is so far, but what does one can request at Noctua one. If your board has no, boot, game boost, etc. The purpose of the whole software packages or

The manual I have taken that the USB ports on the backpanel me not really. To your question 3. there sense? Since I do not have the Noctua NH-U12S SE-AM4 cooler yet: the preassembled frame the individual apps such.

The (backplate?) Probably just needs to be unscrewed to mount the Noctua NH-U12S SE-AM4, right?
5. If you have any concerns that hot spots could form somewhere in the housing and you would like to monitor the temperature at the location?
3. See the manual for part of an AS-Media controller that suspends the CPU and the X370 chipset. Which one of the 8 SATA ports one used should not matter, or (if you do not use M2 SSD)?

Topicality 34.03%

Do you have 2 of it brings the second card! 40% more power ....
Worth getting girlfriend installed in the system and she really found the first cream! I am looking forward to the difference? about your resonances!

As far as the OC'en was concerned, she was top! I have the 7870 OC of Gigabyte at my Bring nothing, except Microruckler ^^
The GTX is stronger than a HD 7870