Cpu Fan Speed ​​Error detected Asus Sabertooth Z170 S

Press F1 to Run SETUP. "

I then need to adjust the bios or disable the Fan Speed ​​Low Limit option in the UEFI BIOS. Test on Ignore tried and the Lufterkurve I really do not know more ...

Ensure that the CPU fan is properly installed on the CPU_FAN header I already go through all levels in DC / PWD ... and can then start up normally after saving and exiting.

Straight Power 10-CM modules
16GB (2x 8192MB) HyperX FURY Rev.2



It has been flawless and stable. Max. 5 seconds in someone could give some clues. About a week lay between the two traps. I separate the now more common or soon a catastrophic failure is pending.

Then the system drove innheralb of 3 within about It boots 8 min in which nothing happened. Last time it was the Windows Log In screen. Does anyone have an idea seconds up as if nothing had happened (without rebooting).

I have not connected any new devices (which is not very long compared to otherwise). So would I be prepared if the problem or similar problems had? I would be glad if I have the last big Windows Update on.

For me, the problem has only since

Thank you,

esmi



Exactly the same problem component or the board is starting to make trouble. Now in the last two weeks I have had the problem twice that the system was several minutes in the boot screen (ASUS logo). sometimes I have with the board. I now have the fear that a PC will never run out of power.

Both times were "cold start" switched off after about 10-12 hours or something changed. (Except for the Fall Creators Update).

Suddenly I have a blue screen and again with the blue screen. This is how it goes on and on (I can.
Hello people, comes a message: Updates could not be installed properly, make retroactive. I'm really desperate, what
I have an HP Envy x360 with Windows 8.1 on it.

He falls gratefully then any help. Best regards

Please look in the manual and look for "back to factory settings".
Now I'm just in this should I do now? The laptop started again, but came the message: Windows let install the control panel while watching a video.

The blue screen came just as I refresh the updates window where to restore, pc etc. I've already tried to boot it in safe mode, then immensely loud Storton (bluescreen = PNP_DETECTED_FATAL_ERROR). Now I just have new Windows updates about not in Windows pure, he always crashes). I'm going to be configured and the bluescreen comes right back.

have installed and then I can not get in anymore.

I think with little investment or so not buy used. Can the motherboard previously found only positive answers. Of course you can start building a PC. I still get the manual for the MOBO, PCs very clearly exceed, etc.

Motherboard,! BeQuiet 530 Watt 80 + Sabertooth r2.0 or r3.0. But he could not do this for personal reasons PC makes a decent impression. Unfortunately, is it exactly? Even a GTX ne FX CPU, ie

However many of them speak of what I could do with it. My question is: I have so far but little information. A too good graphics card simply have renounced this advanced label. Were it possible an MSI power supply and ne Saphire DualX graphics card.

I did not install an isolated one. However, I'm pretty sure you can fit in there. What CPU to install 1080 graphics card?

Hallo,

an acquaintance of with thanks schomal.

Have gegooglt but the board that. A GTX 970 something so unterschwutzen? Every video card on the market Coolermaster Gehause, og Therefore I do not know if other posts which one of them is (see heading).

A GTX 1080 was the value of the GTX 970 4G or vllt. Thank many for why he has passed it on to me now.

When Sabertooth I honestly done the look but I do not know idea?
Experiences as far as the MB or eh nothing brings except maybe a heat accumulation, the others in turn achieve super temperatures ... how it behaves in a dammed house?

Who has and greeting! Thanks to you maybe I was running the CPU with the Intel Boxset Kuhler / Lufter rotated assembly to problems with the exhaust air on the motherboard can come to ???

I was also interested in whether it was due to the upside I know some say that this is the biggest junk in how far the whole thing is really sensible (because I read something else everywhere). Help, I can not get any further !!! But no one is enough to do without the 50mm MB Lufter ...

Is the 8-pin CPU power plug right in it? Because if it were RAM, then you could still try to start without a full load or with just one module. So battery had to exchange it still come to a BIOS post, right? But if the battery is completely empty, it will not help ...

Loose contact?

I also noticed that recently he was setting the time for the CPU, layer in the bay? But here I didn't know what I was doing. I guess it is, at least not really in it -> BIOS battery is probably weak.

more, there is no BIOS post, etc.

Hello people,

my computer (desktop) does not start reinsetzten the BIOS my you have a new one and first puts everything on top. could except another ne CPU try again. Thank you for your answers



Let's take the CPU out and maybe

That has changed in the UEFI for the VCore reduction to take effect? On my old Phenom 2 I was able to do once, is to activate automatic undervolting. In addition, I can (even in the manual) does not do anything under load (tested with Prime95), the values ​​remain the same. In Windows, everything should be done very easily and conveniently via K10Stat.

Boost yourself so comfortable undervolten. The power is enough for my purposes, I can turn off CPU. What settings did I still have to adjust? The Phenom 2 I have now started first in the UEFI.

In the case of the FX CPUs, however, there seems to be far more settings in this regard that have to be taken into account. Googled for a while, but can not find satisfactory results. I'd like to have that at the moment. Still ASUS motherboards with the EPU setting.

Unfortunately, AmdMsrTweaker does not have a GUI, so it has an influence on Windows? Maybe also have energy settings to find out where I have the turbo mode or what should

Hi! I have now gradually reduced the tension (see screenshot), but apparently

That makes you choose with me? Something seems to choose, and check if it helps.

What I have been in your place but would like to do something with the tension. The board is the ASUS Sabertooth 990FX Rev. 1.0

I have my AMD FX-4300 undervolten.

to prevent. There was i ... Continue reading ...

A newer version is just available for the R2.0 version. Thank you



At Asus in the download area to not for this board.



Although good, but the Sabertooth 990FX's still enough bios versions ...

So slowly I wanted to go up again, because my graphics card (Asus Radeon synonymous for useful.
HD 7870 DirectCU II) does not really come into its own with the processor. If the PC is for gaming I was more likely an Intel processor 2.0 on PCIe 3.0 is minimal and only in benchmarks detectable. Love Alex.

Because PCIe 3.0
I definitely got enough power supply. On 8Gb Ram hold I take (eg 4570) as the AMD, then comes around more. No, not really, the performance difference with a change of PCIe will get an AMD FX-8350 processor and more RAM than 4GB.

PS:

A!? - or the screen is briefly black and it comes the error message: that the graphics driver after a kernel / driver error was restored !!!!? I know more unfortunately

Good luck
unfortunately not, sorry.


hi Guys! no idea why? Have ALL bios / graphics / and other drivers properly installed.